r programming analysis of variance anova chapter 8 factorial treatment structure

Please use R codes for all the problems except 8.2 and send me the codes, and also make a clean report and send.

Problem 8.1

Brewer’s malt is produced from germinating barley, so brewers like to know under what conditions they should germinate their barley. The following is part of an experiment on barley germination. Barley seeds were divided into 30 lots of 100 seeds, and each lot of 100 seeds was germinated under one of ten conditions chosen at random. The conditions are the ten combinations of weeks after harvest (1, 3, 6, 9, or 12 weeks) and amount of water used in germination (4 ml or 8 ml). The response is the number of seeds germinating. We are interested in whether timing and/or amount of water affect germination. The data for this problem are in Table 8.1 (Hareland and Madson 1989). Analyze these data to determine how the germination rate depends on the treatments.

Problem 8.2 (For this problem, no calculation, no R, simple tell me whats wrong with this design)

Particleboard is made from wood chips and resins. An experiment is conducted to study the effect of using slash chips (waste wood chips) along with standard chips. The researchers make eighteen boards by varying the target density (42 or 48 lb/ft3 ), the amount of resin (6, 9, or 12%), and the fraction of slash (0, 25, or 50%). The response is the actual density of the boards produced (lb/ft3 , data from Boehner 1975). Analyze these data to determine the effects of the factors on particleboard density and how the density differs from target.

Problem 8.4

Implantable heart pacemakers contain small circuit boards called substrates. These substrates are assembled, cut to shape, and fired. Some of the substrates will separate, or delaminate, making them useless. The purpose of this experiment was to study the effects of three factors on the rate of delamination. The factors were A: firing profile time, 8 versus 13 hours with the theory suggesting 13 hours is better; B: furnace airflow, low versus high, with theory suggesting high is better; and C: laser, old versus new, with theory suggesting new cutting lasers are better. A large number of raw, assembled substrates are divided into sixteen groups. These sixteen groups are assigned at random to the eight factorlevel combinations of the three factors, two groups per combination. The substrates are then processed, and the response is the fraction of substrates that delaminate. Data from Todd Kerkow

Analyze these data to determine how the treatments affect delamination.

“Order a similar paper and get 20% discount on your first order with us Use the following coupon “GET20”

 

Posted in Uncategorized